AN955

[jcurless]

Q: refer to the exhibit. which configuration enables SW2 to establish an LACP EtherChannel?


In the exhibit it shows two Switches listed as SW2. (with below config)
SW1#show run
building configuration
interface GigabitEthernet0/1
   channel-group 2 mode passive
!
interface GigabitEthernet0/2
   channel-group 2 mode passive


The answer it says is correct has different Channel-Group ID's... 

SW2(config)#interface gigabitEthernet0/1
SW2(config)#channel-group 1 mode active
SW2(config)#interface gigabitEthernet0/2
SW2(config)#channel-group 1 mode active


The only answers that list channel-group 2 are mode desirable and auto.

[help_desk]

The question has been corrected. Thank you!