Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
bad question- answer
#1
RTE 753 question doesn't have the correct answer.


OSPF uses router id than highest ip on a  loopback interface and than normal IPV4 interface that is in the UP condition.
So if you configure a new LB ip address and reboot the router. it still uses the original ROUTER ID that was assigned.
Reply


Messages In This Thread
bad question- answer - by rdhooke90 - 09-13-2019, 05:14 PM
RE: bad question- answer - by forumsupport - 09-13-2019, 05:37 PM
RE: bad question- answer - by rdhooke90 - 09-16-2019, 02:53 PM
RE: bad question- answer - by Okdef - 10-16-2019, 10:12 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)