How2pass.com Forums › CCNP › General Discussion v
how do i load a new image on cisco router

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
how do i load a new image on cisco router
themayor
Unregistered
 
#3
02-13-2008, 12:57 PM
hi HTH,

i can not get to the  Router(boot)> prompt even after changing the confreg to 0x2101. i am still at rommon 1 > prompt.
what is suppose to be the settings of the other parameters like the boot, console baud  etc after typing the confreg command?

HTH, before the image was mistakingly erase, it use to boot to the router(boot) prompt. Please, what do i have to do next to get this router up?

thanks for your help in advance

Themayor
Reply


Messages In This Thread
how do i load a new image on cisco router - by themayor - 02-11-2008, 04:38 PM
Re: how do i load a new image on cisco router - by lordflasheart - 02-11-2008, 08:11 PM
Re: how do i load a new image on cisco router - by themayor - 02-13-2008, 12:57 PM
Re: how do i load a new image on cisco router - by directly_connected - 02-17-2008, 10:42 PM
Re: how do i load a new image on cisco router - by directly_connected - 02-17-2008, 10:44 PM
Re: how do i load a new image on cisco router - by directly_connected - 02-17-2008, 11:50 PM
Re: how do i load a new image on cisco router - by grassroot - 02-24-2009, 01:15 AM
Re: how do i load a new image on cisco router - by rehr22 - 02-26-2009, 09:37 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)