next. ec184
[b]An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?[/b]
i think answer is d not a.
the configuration is not complete and just source is defined.
edit. tested in cml. if vlan 50 would be a transit remote span on a middle switch would not show in monitor seesion.
okay question EC176
can someone explain me
[b]Refer to the exhibit. A network engineer configures a GRE tunnel and enters the show Interface tunnel command. What does the output confirm about the configuration[/b]
why the answer is b?
how i see things a b and c are all true. d is not true as default mtu on physical interf is 1500
a keepalives are set to 10s and as far as i know are disabled by default and optional
b interface tracking is configured on g0/1
c as far as i know gre is the default mode
why answer b and not any of a b or c?
edit. tested in cml as well. coorect answer c
[b]An engineer configures monitoring on SW1 and enters the show command to verify operation. What does the output confirm?[/b]
- A. SPAN session 1 monitors activity on VLAN 50 of a remote switch
- B. SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.
- C. SPAN session 2 monitors all traffic entering and exiting port FastEthernet 0/15.
- D. RSPAN session 1 is incompletely configured for monitoring
i think answer is d not a.
the configuration is not complete and just source is defined.
edit. tested in cml. if vlan 50 would be a transit remote span on a middle switch would not show in monitor seesion.
okay question EC176
can someone explain me
[b]Refer to the exhibit. A network engineer configures a GRE tunnel and enters the show Interface tunnel command. What does the output confirm about the configuration[/b]
- A. The keepalive value is modified from the default value.
- B. Interface tracking is configured.
- C. The tunnel mode is set to the default.
- D. The physical interface MTU is 1476 bytes.
why the answer is b?
how i see things a b and c are all true. d is not true as default mtu on physical interf is 1500
a keepalives are set to 10s and as far as i know are disabled by default and optional
b interface tracking is configured on g0/1
c as far as i know gre is the default mode
why answer b and not any of a b or c?
edit. tested in cml as well. coorect answer c