pablo701
06-02-2011, 12:38 PM
Admin or Forum:
can you please explain the answer to question QID:RTE217?
This a question about redistribution between RIPV2 and OSPF (and vice-versa) and avoiding routing loops.
I think what needs to be done is to make sure that the routes advertised from OSPF to RIP and not advertized back from RIP to OSPF.
However, I do not understand how the the access-list with a deny clause works with the route-map with a deny clause.
I think the answer is not correct.
we need to stop 10.1.1.0 from being redistributed from RIP back to OSPF
stated answer:
access-list 15 deny 10.1.1.0 0.0.0.63
access-list 15 permit any <-------
The above ACL will pass to the route-map shown below all routes except 10.1.1.0
However the deny clause in the route-map will block all these routes from being redistributed - not the outcome be are looking for.
route-map redis-rip deny 10
match ip address 15
If you keep the ACL as-is, that is the ACL will pass all the routes that can be redistributed, then the route-map needs just one block:
route-map redis permit 10
match ip address 15.
"The route-map redis permit 20" is not needed.
(: all previous how2pass exams I had used had very good answer explanations. This 642-902 how2pass exam has a very high number of unexplained answers.
pablo
can you please explain the answer to question QID:RTE217?
This a question about redistribution between RIPV2 and OSPF (and vice-versa) and avoiding routing loops.
I think what needs to be done is to make sure that the routes advertised from OSPF to RIP and not advertized back from RIP to OSPF.
However, I do not understand how the the access-list with a deny clause works with the route-map with a deny clause.
I think the answer is not correct.
we need to stop 10.1.1.0 from being redistributed from RIP back to OSPF
stated answer:
access-list 15 deny 10.1.1.0 0.0.0.63
access-list 15 permit any <-------
The above ACL will pass to the route-map shown below all routes except 10.1.1.0
However the deny clause in the route-map will block all these routes from being redistributed - not the outcome be are looking for.
route-map redis-rip deny 10
match ip address 15
If you keep the ACL as-is, that is the ACL will pass all the routes that can be redistributed, then the route-map needs just one block:
route-map redis permit 10
match ip address 15.
"The route-map redis permit 20" is not needed.
(: all previous how2pass exams I had used had very good answer explanations. This 642-902 how2pass exam has a very high number of unexplained answers.
pablo