How2pass.com Forums

(08-11-2020, 04:54 PM)how2makeit Wrote: [ -> ]

(08-10-2020, 05:11 PM)forumsupport Wrote: [ -> ]These are 13 new questions. Yes, two users have confirmed that these are valid questions.

can you confirm those new 13 questions answers are accurate and correct because i found a new pdf file from different source and there are a huge different with the answers with some questions and some new questions addes such as:
********************************************************************************

Refer to the exhibit. The network administrator configured VRF lite for customer A. The technician at the remote site misconfigured VRF on the router. Which configuration will resolve connectivity for both sites of customer A?

A.
ip vrf customer_a
rd 1:2
route-target both 1:1
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Which label operations are performed by a label edge router?

D. PUSH and POP
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
After some changes in the routing policy, it is noticed that the router in AS 45123 is being used as a transit AS router for several service providers. Which configuration ensures that the branch router in AS 45123 advertises only the local networks to all SP neighbors?

C.
ip as-path access-list 1 permit ^$
!
router bgp 45123
neighbor SP-Neighbors filter-list 1 out
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Refer to the exhibit. A junior engineer updated a branch router configuration. Immediately after the change, the engineer receives calls from the help desk that branch personnel cannot reach any network destinations. Which configuration restores service and continues to block 10.1.1.100/32?

B. route-map FILTER-IN permit 20
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
New Question
What is an advantage of using BFD?
A. It detects local link failure at layer 1 and updates routing table
B. It detects local link failure at layer 3 and updates routing protocols
C.It has sub-second failure detection for layer 1 and layer 2 problems
D. It has sub-second failure detection for layer 1 and layer 3 problems

Answer: C
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
New Question
Refer to the exhibit. The ACL is placed on the inbound GigabitEthernet 0/1 interface of the router. Host 192.168.10.10 cannot SSH to host 192.168.100.1 even though the flow is permitted. Which action resolves the issue without opening full access to this router?

A. Temporarily move the permit ip any any line to the beginning of the ACL to see if it the flow works
B. Run the show access-list FILTER command to view if the SSH entry has any hit statistics associated with it
C. Move the SSH entry to the beginning of the ACL
D. Temporarily remove the ACL from the interface to see if the flow works

Answer: C
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
New Question
Which component of MPLS VPN is used to extend the IP address so that an engineer is able to identify to which VPN it belongs?

A. RD
B. VPNv4 address family
C. RT
D. LDP

Answer: A
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
New Question
Refer to the exhibit. BGP is flapping after the CoPP policy is applied. What are the two solutions to fix the issue? (Choose two)

policy-mapp COPP-7600
class COPP-CRITICAL-7600
police cir 2000000 bc 62500
conform-action transmit
exceed-action transmit
!
class class-default
police cir 2000000 bc 6250
conform-action transmit
exceed-action drop
!
class-map match-all COPP-CRITICAL-7600
match access-group name COPP-CRITICAL-7600
!
ip access-list extended COPP-CRITICAL-7600
permit ip any any eq http
permit ip any any eq https


A. Configure BGP in the COPP-CRITICAL-7600 ACL
B. Configure a higher value for CIR under the default class to allow more packets during peak traffic
C. Configure a higher value for CIR under the class COPP-CRITICAL-7600
D. Configure a three-color policer instead of two-color policer under class COPP-CRITICAL-7600
E. Configure IP CEF to CoPP policy and BGP to work

Answer: A B



Hello,
I've tooked the exam today and failed for couple of questions. I prepared myself from another source and they didn't implement new questions. I can confirm that every single one of these new 13 questions I had on exam. Of course there were more new ones, let's say around 5-10. I remember there were couple of new questions for IP SLA, and one big picture of three routing protocols with pretty complicated answers. So I would recommend to wait little more for more updates.

(08-15-2020, 06:39 PM)forumsupport Wrote: [ -> ]We have now 18 new questions.

Many answers in the pdf files of other web sites are incorrect. There is the least chance of incorrect answers in our questions.

This is not enough to say that some of our answers are different from some other vendor. Most of our questions provide explanation or a reference. If you you disagree, please do your investigation and point out the error along with a reason or reference.  When any user points out an error, along with a reason or reference, we will fix it immediately.

(08-15-2020, 06:39 PM)forumsupport Wrote: [ -> ]We have now 18 new questions.

Many answers in the pdf files of other web sites are incorrect. There is the least chance of incorrect answers in our questions.

This is not enough to say that some of our answers are different from some other vendor. Most of our questions provide explanation or a reference. If you you disagree, please do your investigation and point out the error along with a reason or reference.  When any user points out an error, along with a reason or reference, we will fix it immediately.