Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Question QID:N514
#2
This is a tricky question, you have to realize that each switch will set its own blocking and forwarding state based on it's place in the network. Think about it like this:

SW1-B--------------------SW2                  SW3 is the root bridge so all of it's links are in the designated state, including the 100Mb/s link. Remember
B  +                          +  B                    the STP cost numbers, 100Mb/s = 19, Gb/s = 4. If you add up the link from SW1 to SW3 the direct route is 
|        +                +      |                    19. But the route that toes SW1-SW4-SW3 (4+4 = 8) and is lower then the direct link and will be used. The
|            +      +            |                      goes for the link between SW1 and SW2, SW1-SW4-SW3-SW4 (4+4+4 = 12) vs the direct link cost of 19. Do
|                  +                |                      numbers for the last one SW2 to SW4 and you'll see the lower cost is more hops.
|            +      +            | 
|        +                +      |                    Then notice that the lower Router ID between two non-root bridges has the open port.
|    +                        +  |
SW3+++++++++++++SW4


----- & | = 100 MB/s
+++++ = 1 Gb/s
B          = Blocking state
Reply


Messages In This Thread
Question QID:N514 - by taetak101 - 04-10-2009, 07:45 PM
Re: Question QID:N514 - by fucher - 06-02-2009, 11:58 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)